Diagnostic Test

REPLACE COMBINATION METER

Replace combination meter. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 2 .

WRITING VEHICLE SPECIFICATION

CONSULT Configuration

Perform "Read / Write Configuration". Refer to DESCRIPTION .

GO TO STEP 3 .

PERFORM RE LEARNING

With CONSULT

Perform "Re learning". Refer to DESCRIPTION .

GO TO STEP 4 .

CHECK ALL ECU SELF - DIAGNOSIS RESULTS
1. Erase all ECU self - diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self - diagnosis results have no DTC of CAN communication.
WORK END