Diagnosis Procedure: B210D-16

Check battery voltage.

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair or replace the malfunctioning parts.

Check that the following fuse are not blown.

Is the fuse blown (open)?

YES 

Replace the blown fuse after repairing the affected circuit if a fuse is blown.

NO 

GO TO STEP 3  .

1. Turn ignition switch OFF.
2. Disconnect combination meter connector.
3. Turn ignition switch ON.
4. Check the voltage between combination meter harness connector and ground.

   Probe			Standard	Voltage (Approx.)
   (+)		(-)
   Combination meter
   Connector	Terminal
   M32	4	Ground	11.0 V - 15.5 V	Battery voltage

Is the inspection result normal?

YES 

Check electrical lines and connectors for loose contact and corrosion.

NO 

GO TO STEP 4  .

Check battery. Refer to WORK PROCEDURE .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Repair or replace the malfunctioning parts.

Check charging system condition. Refer to WORK FLOW (WITH EXP-800 NI OR GR8-1200 NI) (With EXP-800 NI or GR8-1200 NI) or WORK FLOW (WITHOUT EXP-800 NI OR GR8-1200 NI) (Without EXP-800 NI or GR8-1200 NI).

Is the inspection result normal?

YES 

Replace combination meter. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace the malfunctioning parts.