DTC Detection Logic
| DTC | CONSULT screen terms | DTC detection condition | |||
|---|---|---|---|---|---|
| (Trouble diagnosis content) | [Malfunction type] | ||||
| B210A | 84 | Power Supply circuit (The power supply in the system is too low) |
SIG BELOW ALLOWABLE RANGE | Diagnosis condition | Ignition switch is ON |
| Signal (terminal) | Battery voltage signal (CAN message from electronic ignition switch control unit) |
||||
| Threshold | Battery voltage signal < 10 V +- 0.2 V | ||||
| Diagnosis delay time | 60 seconds or more | ||||
NOTE:
The DTC is set if the value for the battery power supply voltage received via the CAN bus is below the permissible voltage range.