LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> QX30 Base >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> LAN System (Can) >> DTC/Circuit Diagnosis >> Can PDEC (Body) - A/C Auto Amp. Circuit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK HARNESS CONNECTOR CONNECTION

    Check the following harness connector for disconnection or looseness.

    • CAN potential distributor electrical connector (body)
    • A/C auto amp.

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Securely connect the harness connectors.

  2. CHECK POWER SUPPLY AND GROUND CIRCUIT

    Check power supply and ground circuit for A/C auto amp. Refer to DIAGNOSIS PROCEDURE .

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace the malfunctioning part.

  3. CHECK CIRCUIT (SHORT TO BATTERY)

    1. Turn ignition switch OFF.
    2. Disconnect the following unit connectors.
      • CAN potential distributor electrical connector (body)
      • A/C auto amp.
    3. Check voltage between CAN potential distributor electrical connector (body) harness connector and ground.
      Terminals Voltage
      (Approx.)
      + -
      CAN potential distributor electrical connector (body) Ground
      Connector Terminal
      M298 6 - 0 V
      7

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    Repair or replace harness.

  4. CHECK CIRCUIT (SHORT TO GROUND)

    Check continuity between CAN potential distributor electrical connector (body) harness connector and ground.

    CAN potential distributor electrical connector (body) Ground Continuity
    Connector Terminal
    M298 6 - Not existed
    7

    Is the inspection result normal?

    YES 

    GO TO STEP 5  .

    NO 

    Repair or replace harness.

  5. CHECK CIRCUIT (SHORT WITH CAN-H AND CAN-L)

    Check continuity between CAN potential distributor electrical connector (body) harness connector terminals.

    CAN potential distributor electrical connector (body) Continuity
    Connector Terminal Connector Terminal
    M298 6 M298 7 Not existed

    Is the inspection result normal?

    YES 

    GO TO STEP 6  .

    NO 

    Repair or replace harness.

  6. CHECK CIRCUIT (OPEN)

    Check continuity between the following unit harness connectors.

    • CAN potential distributor electrical connector (body)
    • A/C auto amp.
      CAN POTENTIAL DISTRIBUTOR ELECTRICAL CONNECTOR (BODY) - A/C AUTO AMP.

      CAN potential distributor electrical connector (body) A/C auto amp. Continuity
      Connector Terminal Connector Terminal
      M298 6 M36 5 Existed
      7 4

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Repair or replace harness.

scientia non olet · About LEMON Manuals