LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q60 Base, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door & Lock (DTC/Circuit Diagnosis) >> DTC/Circuit Diagnosis >> DTC B2626: Outside Antenna >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1

    1. Turn Ignition Switch ON.
    2. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference Value)
      BCM
      Connector Terminal
      M16 114, 115 Ground When pressing the door request switch (passenger side) with all doors are locked and Ignition Switch ON When Intelligent Key is not in the antenna detection area
      GNSJMMIA2313GB-313Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is in the antenna detection area
      GNSJMMIA2314GB-314Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .

    NO 

    GO TO STEP 2  .

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT

    1. Turn Ignition Switch OFF.
    2. Disconnect BCM connector and One Touch Unlock Sensor Assembly (Passenger Side) connector.
    3. Check continuity between BCM harness connector and One Touch Unlock Sensor Assembly (Passenger Side) harness connector.
      BCM One Touch Unlock Sensor Assembly (Passenger Side) Continuity
      Connector Terminal Connector Terminal
      M16 114 D22 1 Existed
      115 4
    4. Check continuity between BCM harness connector and ground.
      BCM Ground Continuity
      Connector Terminal
      M16 114 Not existed
      115

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2

    1. Replace outside handle grip RH. (New antenna or other antenna)
    2. Connect BCM connector and One Touch Unlock Sensor Assembly (Passenger Side) connector.
    3. Turn Ignition Switch ON.
    4. Check signal between BCM harness connector and ground using oscilloscope.
      (+) (-) Condition Signal
      (Reference Value)
      BCM
      Connector Terminal
      M16 114, 115 Ground When pressing the door request switch (passenger side) with all doors are locked and Ignition Switch ON When Intelligent Key is not in the antenna detection area
      GNSJMMIA2313GB-313Courtesy of NISSAN NORTH AMERICA, INC.
      When Intelligent Key is in the antenna detection area
      GNSJMMIA2314GB-314Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    Replace outside handle grip RH.

    NO 

    Replace BCM. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals