Diagnosis Procedure
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1
- Turn Ignition Switch ON.
- Check signal between BCM harness connector and ground using oscilloscope.
(+) (-) Condition Signal
(Reference Value)BCM Connector Terminal M15 99 Ground Ignition Switch ON and any door is open When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area 100 When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area
Is the inspection result normal?
YES
Replace BCM. Refer to REMOVAL AND INSTALLATION .
NO
GO TO STEP 2 .
- CHECK INSIDE KEY ANTENNA CIRCUIT
- Turn Ignition Switch OFF.
- Disconnect BCM connector and Inside Key Antenna (Trunk Room) connector.
- Check continuity between BCM harness connector and Inside Key Antenna (Trunk Room) harness connector.
BCM Inside Key Antenna (Trunk Room) Continuity Connector Terminal Connector Terminal M15 99 B71 2 Existed 100 1 - Check continuity between BCM harness connector and ground.
BCM Ground Continuity Connector Terminal M15 99 Not existed 100
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness.
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2
- Replace Inside Key Antenna (Trunk Room). (New antenna or other antenna)
- Connect BCM connector and Inside Key Antenna (Trunk Room) connector.
- Turn Ignition Switch ON.
- Check signal between BCM harness connector and ground using oscilloscope.
(+) (-) Condition Signal
(Reference Value)BCM Connector Terminal M15 99 Ground Ignition Switch ON and any door is open When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area 100 When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area
Is the inspection result normal?
YES
Replace Inside Key Antenna (Trunk Room).
NO
Replace BCM. Refer to REMOVAL AND INSTALLATION .