Diagnosis Procedure
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1
- Turn Ignition Switch ON.
- Check signal between BCM harness connector and ground with oscilloscope.
(+) (-) Condition Signal
(Reference value)BCM Connector Terminal M16 123 Ground Ignition Switch ON and any door is open When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area 124 When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area
Is the inspection result normal?
YES
Replace BCM. Refer to REMOVAL AND INSTALLATION .
NO
GO TO STEP 2 .
- CHECK INSIDE KEY ANTENNA CIRCUIT
- Turn Ignition Switch OFF.
- Disconnect BCM connector and Inside Key Antenna (Instrument Lower) connector.
- Check continuity between BCM harness connector and Inside Key Antenna (Instrument Lower) harness connector.
BCM Inside Key Antenna (Instrument Lower) Continuity Connector Terminal Connector Terminal M16 123 M109 1 Existed 124 2 - Check continuity between BCM harness connector and ground.
BCM Ground Continuity Connector Terminal M16 123 Not existed 124
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness.
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2
- Replace Inside Key Antenna (Instrument Lower). (New antenna or other antenna)
- Connect BCM connector and Inside Key Antenna (Instrument Lower) connector.
- Check signal between BCM harness connector and ground with oscilloscope.
(+) (-) Condition Signal
(Reference Value)BCM Connector Terminal M16 123 Ground Ignition Switch ON and any door is open When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area 124 When Intelligent Key is not in the antenna detection area When Intelligent Key is in the antenna detection area
Is the inspection result normal?
YES
Replace Inside Key Antenna (Instrument Lower).
NO
Replace BCM. Refer to REMOVAL AND INSTALLATION .