With ICC
- CHECK STEERING SWITCH SIGNAL A CIRCUIT
- Disconnect Combination Meter harness connector and Spiral Cable harness connector.
- Check continuity between Combination Meter harness connector and Spiral Cable harness connector.
Combination Meter Spiral Cable Continuity Connector Terminal Connector Terminal M57 22 M190 34 Existed - Check continuity between Combination Meter harness connector and ground.
Combination Meter Ground Continuity Connector Terminal M57 22 Not existed
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair harness or connector.
- CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT
- Check continuity between Combination Meter harness connector and Spiral Cable harness connector.
Combination Meter Spiral Cable Continuity Connector Terminal Connector Terminal M57 21 M190 32 Existed - Check continuity between Combination Meter harness connector and ground.
Combination Meter Ground Continuity Connector Terminal M57 21 Not existed
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair harness or connector.
- Check continuity between Combination Meter harness connector and Spiral Cable harness connector.
- CHECK SPIRAL CABLE
- Disconnect Steering Switch connector.
- Check continuity between Spiral Cable harness connectors.
Spiral Cable Continuity Terminal 34 13 Existed 32 15
Is the inspection result normal?
YES
GO TO STEP 4.
NO
Replace Spiral Cable. Refer to REMOVAL AND INSTALLATION .
- CHECK STEERING SWITCH
Check Steering Switch. Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace Steering Switch. Refer to REMOVAL AND INSTALLATION .