Component Function Check

1. Turn Ignition Switch ON.
2. Measure voltage between the following terminals of the Combination Meter.

   Combination Meter			Condition	Voltage (Approx.)
   Connector	Terminals
   	(+)	(-)
   M57	36	17	When Illumination Control Switch (+) is pressed	0 V
   			Other than the above	5.0 V
   	37		When Illumination Control Switch (-) is pressed	0 V
   			Other than the above	5.0 V
   	18		When Trip Reset Switch is pressed	0 V
   			Other than the above	5.0 V

Is the inspection result normal?

YES 

INSPECTION END

NO 

Refer to DIAGNOSIS PROCEDURE .