Diagnostic Test

1. Perform "All DTC Reading" with CONSULT.
2. Check if the DTC is detected in self-diagnosis results for "ICC/ADAS" with CONSULT. Refer to

   .

Is any DTC detected?

YES 

GO TO STEP 6  .

NO 

GO TO STEP 2  .

1. Start the engine.
2. Check that "FEB SELECT" operates normally in "DATA MONITOR" for "ICC/ADAS" with CONSULT.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

GO TO STEP 3  .

Check if any DTC is detected in "Self Diagnostic Result" of "MULTI AV". Refer to DTC INDEX .

Is any DTC detected?

YES 

Repair or replace the malfunctioning parts identified by the self-diagnosis result.

NO 

Replace the ADAS Control Unit. Refer to REMOVAL AND INSTALLATION .

1. Start the engine.
2. Select the active test item "METER LAMP" for "ICC/ADAS" with CONSULT.
3. Check if the FEB warning lamp illuminates when the test item is operated.

Is the inspection result normal?

YES 

Refer to WORK FLOW .

NO 

GO TO STEP 5  .

Check that "BA W/L" operates normally in "DATA MONITOR" for "METER/M&A" with CONSULT, when the FEB setting ON by integral Switch.

Is the inspection result normal?

YES 

Replace the Combination Meter. Refer to REMOVAL AND INSTALLATION .

NO 

Replace the ADAS Control Unit. Refer to REMOVAL AND INSTALLATION .

Repair or replace malfunctioning parts.

GO TO STEP 7  .

Check that FEB warning lamp turned ON → OFF, when operating integral Switch.

INSPECTION END