DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always drive vehicle at a safe speed.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO STEP 2.

CHECK DTC HIGH VOLTAGE COOLING SYSTEM
1. Set the vehicle to READY.
2. Drive the vehicle by motor.
3. Fully open the accelerator and accelerate the vehicle to 60 km/h (37 MPH).
4. Stop the vehicle.
5. Perform "Self Diagnostic Results" in "EV/HEV".
Is any DTC detected?

YES

Check DTC detected item. Refer to DTC INDEX .

NO

GO TO STEP 3.

CHECK DTC DETECTION

Check DTC.

Is "P324D" detected?

YES

Go to DIAGNOSIS PROCEDURE .

NO-1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2

Confirmation after repair: INSPECTION END