DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2.
- CHECK DTC HIGH VOLTAGE SYSTEMS
- Set the vehicle to READY and start the engine and then wait for 10 seconds or more.
- Check DTC of the high voltage systems.
Were there any detected DTC related to a high voltage systems other than the traction motor inverter?
YES
Check DTC detected item.
NO
GO TO STEP 3.
- CHECK DTC DETECTION
Check DTC.
Is "P3244" detected?
YES
Go to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END