LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Steering Control System (Diagnostic Trouble Codes (DTCS) C13D4-00 - U1010-49 And Circuit Diagnosis) (Hybrid)) >> DTC/Circuit Diagnosis >> DTC C13F2-00: Mismatched Software Version >> EPS/DAST 3 >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK THE WORK

    Check the work performed just before.

    What is the work performed just before?

    RE/PROGRAMMING 

    Perform the "RE/PROGRAMMING" according to the procedure. Refer to "CONSULT Operation information",

    Replacing control module 

    When replacing the control module, replace three control modules as a set. Refer to REMOVAL AND INSTALLATION , REMOVAL AND INSTALLATION , REMOVAL AND INSTALLATION . After replacing three control modules, re-preform the self-diagnosis, and then check that DTC"C13F2 - 00" is not detected.

scientia non olet · About LEMON Manuals