Wheel Alignment
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If the vehicle is equipped with the ICC system and the rear toe has been adjusted during a wheel alignment, the ICC sensor must be aligned. Refer to DESCRIPTION (TYPE 1) or DESCRIPTION (TYPE 2).
| Item | Standard | ||
|---|---|---|---|
| Camber Degree minute (Decimal degree) |
Minimum | -1° 05' (-1.08°) | |
| Nominal | -0° 20' (-0.33°) | ||
| Maximum | 0° 25' (0.41°) | ||
| Left and right difference | 0° 33' (0.55°) or less | ||
| Caster Degree minute (Decimal degree) |
Minimum | 3° 20' (3.34°) | |
| Nominal | 4° 40' (4.62°) | ||
| Maximum | 6° 00' (6.00°) | ||
| Left and right difference | 0° 39' (0.65°) or less | ||
| Kingpin inclination Degree minute (Decimal degree) |
Minimum | 6° 35' (6.59°) | |
| Nominal | 7° 20' (7.33°) | ||
| Maximum | 8° 05' (8.08°) | ||
| Toe-in | Total toe-in Distance |
Minimum | Out 1 mm (Out 0.03 in) |
| Nominal | In 1 mm (In 0.04 in) | ||
| Maximum | In 3 mm (In 0.11 in) | ||
| Total toe-angle Degree minute (Decimal degree) |
Minimum | Out 0° 04' 48' (Out 0.08°) | |
| Nominal | In 0° 04' 48' (In 0.08°) | ||
| Maximum | In 0° 14' 24' (In 0.24°) | ||
Measure value under unladen * conditions.
* : Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.