Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR

Perform neutral position adjustment of steering angle sensor. Refer to DESCRIPTION .

GO TO STEP 2 .

CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

With CONSULT
1. Turn the ignition switch OFF.
  NOTE:
  Wait at least 10 seconds after turning ignition switch OFF.
2. Set the vehicle to READY/Start the engine.
  NOTE:
  Wait at least 10 seconds after set the vehicle to READY/start the engine.
3. Repeat step 1 to 2 two or more times.
4. Perform self-diagnosis for "ABS".
Is DTC "C1144" detected?

YES

GO TO STEP 3 .

NO

INSPECTION END

CHECK STEERING ANGLE SENSOR SYSTEM
1. Turn the ignition switch OFF.
2. Check the steering angle sensor system. Refer to DIAGNOSIS PROCEDURE .
Is the inspection result normal?

YES

GO TO STEP 4 .

NO

Repair / replace harness, connector, or terminal.

CHECK DATA MONITOR

With CONSULT
1. "ABS", "DATA MONITOR" and "STR ANGLE SIG" according to this order.
2. Check that the indication changes with the steering angle when the steering wheel is turned left/right from the neutral position. Refer to REFERENCE VALUE .
Is the inspection result normal?

YES

Replace the ABS actuator and electric unit (control unit). Refer to REMOVAL AND INSTALLATION .

NO

Replace the steering angle sensor. Refer to REMOVAL AND INSTALLATION .