DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT
1. Turn the ignition switch OFF, and wait 10 seconds or more.
2. Set the vehicle to READY/Start the engine.
  NOTE:
  Stop the vehicle.
3. Wait 1 minute or more.
  NOTE:
  Never depress brake pedal.
4. Depress brake pedal by 100 mm (3.94 in) or more, and maintain at that position for a minimum of 1 minute or more.
5. Release brake pedal, and wait 1 minute or more.
6. Repeat step 4 to 5 ten or more times.
7. Turn the ignition switch OFF.
  NOTE:
  Wait at least 10 seconds after turning ignition switch OFF.
8. Set the vehicle to READY/Start the engine.
  NOTE:
  Wait at least 10 seconds after set the vehicle to READY/start the engine.
9. Repeat step 7 to 8 two or more times.
10. Perform self-diagnosis for "ABS".
Is DTC "C1116" detected?

YES - 1

"CRNT" is displayed: Proceed to DIAGNOSIS PROCEDURE .

YES - 2

"PAST" is displayed: INSPECTION END (Erase the memory of self - diagnosis results.)

NO-1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2

Confirmation after repair: INSPECTION END