Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect tilt & telescopic motor connector.
3. Turn ignition switch ON.
4. Perform "Active test" ("TILT MOTOR") with CONSULT.
5. Check voltage between tilt & telescopic motor harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Tilt & telescopic motor
   Connector	Terminals
   M28	7	Ground	TILT MOTOR	OFF	0 - 1
   				UP	0 - 1
   				DWN (down)	9 - 16
   	3			OFF	0 - 1
   				UP	9 - 16
   				DWN (down)	0 - 1

Is the inspection result normal?

YES 

Replace tilt & telescopic motor.

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit.
3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic motor harness connector.

   Automatic drive positioner control unit		Tilt & telescopic motor		Continuity
   Connector	Terminal	Connector	Terminal
   M44	28	M28	7	Existed
   	29		3

4. Check continuity between automatic drive positioner control unit harness connector and ground.

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M44	28		Not existed
   	29

Is the inspection result normal?

YES 

Replace automatic drive positioner control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness or connector.