Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect tilt & telescopic motor connector.
3. Turn ignition switch ON.
4. Perform "Active test" ("TELESCO MOTOR") with CONSULT.
5. Check voltage between tilt & telescopic motor harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Tilt & telescopic motor
   Connector	Terminals
   M28	10	Ground	TELESCO MOTOR	OFF	0 - 1
   				FR (forward)	0 - 1
   				RR (backward)	9 - 16
   	4			OFF	0 - 1
   				FR (forward)	9 - 16
   				RR (backward)	0 - 1

Is the inspection result normal?

YES 

Replace tilt & telescopic motor (built in steering column assembly).

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit.
3. Check continuity between automatic drive positioner control unit harness connector and tilt & telescopic motor harness connector.

   Automatic drive positioner control unit		Tilt & telescopic motor		Continuity
   Connector	Terminal	Connector	Terminal
   M44	26	M28	10	Existed
   	29		4

4. Check continuity between automatic drive positioner control unit harness connector and ground.

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M44	26		Not existed
   	29

Is the inspection result normal?

YES 

Replace automatic drive positioner control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness or connector.