Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect sliding motor connector.
3. Turn ignition switch ON.
4. Perform "Active test" ("SEAT SLIDE") with CONSULT.
5. Check voltage between sliding motor harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Sliding motor
   Connector	Terminal
   B604	38	Ground	SEAT SLIDE	OFF	0 - 1
   				FR (forward)	9 - 16
   				RR (backward)	0 - 1
   	34			OFF	0 - 1
   				FR (forward)	0 - 1
   				RR (backward)	9 - 16

Is the inspection result normal?

YES 

Replace sliding motor (built in seat slide cushion frame).

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect driver seat control unit connector.
3. Check continuity between driver seat control unit harness connector and sliding motor harness connector.

   Driver seat control unit		Sliding motor		Continuity
   Connector	Terminal	Connector	Terminal
   B602	34	B604	34	Existed
   	38		38

4. Check continuity between driver seat control unit harness connector and ground.

   Driver seat control unit		Ground	Continuity
   Connector	Terminal
   B602	34		Not existed
   	38

Is the inspection result normal?

YES 

Replace driver seat control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness or connector.