Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect reclining motor connector.
3. Turn ignition switch ON.
4. Perform "Active test" ("SEAT RECLINING") with CONSULT.
5. Check voltage between reclining motor harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Reclining motor
   Connector	Terminal
   B605	35	Ground	SEAT RECLINING	OFF	0 - 1
   				FR (forward)	9 - 16
   				RR (backward)	0 - 1
   	39			OFF	0 - 1
   				FR (forward)	0 - 1
   				RR (backward)	9 - 16

Is the inspection result normal?

YES 

Replace reclining motor (built in seat back frame).

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect driver seat control unit connector.
3. Check continuity between driver seat control unit harness connector and reclining motor harness connector.

   Driver seat control unit		Reclining motor		Continuity
   Connector	Terminal	Connector	Terminal
   B602	35	B605	35	Existed
   	39		39

4. Check continuity between driver seat control unit harness connector and ground.

   Driver seat control unit		Ground	Continuity
   Connector	Terminal
   B602	35		Not existed
   	39

Is the inspection result normal?

YES 

Replace driver seat control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness or connector.