Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect power window main switch (door mirror remote control switch) connector.
3. Turn ignition switch ON.
4. Check voltage between power window main switch (door mirror remote control switch) harness connector and ground.

   (+)		(-)	Voltage (V)
   Power window main switch (door mirror remote control switch)
   Connector	Terminal
   D55	23	Ground	4 - 6
   	28

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit connector.
3. Check continuity between automatic drive positioner control unit harness connector and power window main switch (door mirror remote control switch) harness connector.

   Automatic drive positioner control unit		Power window main switch (door mirror remote control switch)		Continuity
   Connector	Terminal	Connector	Terminal
   M43	2	D55	28	Existed
   	14		23

4. Check continuity between automatic drive positioner control unit harness connector and ground.

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M43	2		Not existed
   	14

Is the inspection result normal?

YES 

Replace automatic drive positioner control unit. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

1. Turn ignition switch OFF.
2. Check continuity between power window main switch (door mirror remote control switch) harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Check changeover switch on power window main switch (door mirror remote control switch).

Refer to COMPONENT FUNCTION CHECK .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace power window main switch (door mirror remote control switch). Refer to REMOVAL AND INSTALLATION .

Check intermittent incident.

Refer to INTERMITTENT INCIDENT .

INSPECTION END