Diagnostic Test

CHECK TILT SWITCH

Turn ignition switch OFF.
Disconnect tilt & telescopic switch connector.

Check continuity between tilt & telescopic switch terminals.

Tilt switch		Condition		Continuity
Terminal		Condition		Continuity
1	4	Tilt switch (upward)	Operate	Existed
	4	Tilt switch (upward)	Release	Not existed
	5	Tilt switch (downward)	Operate	Existed
	5	Tilt switch (downward)	Release	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace tilt & telescopic switch. Refer to REMOVAL AND INSTALLATION .