Active Adaptive Front-Lighting System: Fail-Safe
| DTC No. | CONSULT screen terms | Fail - safe | |
|---|---|---|---|
| Swivel operation | Aiming operation | ||
| B2008 | PARA NOT PROG | Right and left swivel motors stop at the position when DTC is detected | Right and left headlamp aiming motors stop at the position when DTC is detected |
| B2503 | SWIVEL ACTUATOR [RH] |
|
The signal, approximately 2 V decreased from the aiming motor drive signal when DTC detected, is output |
| SWIVEL ACTUATOR [RH] COMM ERROR |
|
||
| B2504 | SWIVEL ACTUATOR [LH] |
|
The signal, approximately 2 V decreased from the aiming motor drive signal when DTC detected, is output |
| SWIVEL ACTUATOR [LH] COMM ERROR |
|
||
| B2512 | 4WAS SIG | Right and left swivel motor swivel angle returns to 0° and fixed | - |
| B2514 | HI SEN UNUSUAL [RR] | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected |
| B2516 | SHIFT POS SIG[R, P] | Right and left swivel motor swivel angle returns to 0° and fixed | - |
| B2517 | VEHICEL SPEED SIG | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected |
| B2519 | LEVELIZER CALIB | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected |
| B2521 | ECU CIRC | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected |
| U0126 | ST ANG SEN SIG | Right and left swivel motor swivel angle returns to 0° and fixed | - |
| U0428 | ST ANG SEN CALIB | Right and left swivel motor swivel angle returns to 0° and fixed | - |
| U1000 | CAN COMM CIRCUIT | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected
NOTE:
Only when the vehicle speed signal or the low beam status signal cannot be received |
| U1010 | CONTROL UNIT(CAN) | Right and left swivel motor swivel angle returns to 0° and fixed | Right and left headlamp aiming motors stop at the position when DTC is detected |