LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q50 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System (Led Headlamp) (Introduction, Wiring Diagrams And Basic Inspection) (Except Hybrid) >> System Description >> Diagnosis System (IPDM E/R) >> Diagnosis Description >> Auto Active Test >> Operation Procedure

Operation Procedure

CAUTION:

Wiper arm interferes with hood when wiper is operated while wiper arm is in the raised position. Always perform auto active test without setting wiper arm in the raised position. Always pour water on front windshield glass in advance to auto active test so that damage on front windshield glass surface is prevented.

NOTE:

Never perform auto active test in the following conditions.

  • CONSULT is connected
  • Passenger door is open
  1. Turn the ignition switch OFF.
  2. Turn the ignition switch ON, and within 20 seconds, press the driver door switch 10 times. Then turn the ignition switch OFF.
  3. Turn the ignition switch ON within 10 seconds. After that the horn sounds once and the auto active test starts.
    NOTE:

    Engine starts when ignition switch is turned ON while brake pedal is depressed.

  4. Oil pressure warning lamp starts blinking when the auto active test starts.
  5. After a series of the following operations is repeated 3 times, auto active test is completed.
    NOTE:
    • When auto active test mode has to be cancelled halfway through test, turn the ignition switch OFF.
    • When auto active test is not activated, door switch may be the cause. Check door switch. Refer to COMPONENT FUNCTION CHECK .
scientia non olet · About LEMON Manuals