LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2017 >> Q50 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System (Led Headlamp) (Introduction, Wiring Diagrams And Basic Inspection) (Except Hybrid) >> Basic Inspection >> Led Headlamp Operation Inspection >> Work Procedure >> Diagnostic Test

Diagnostic Test

  1. CHECK START

    1. In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
    2. In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable status (approximately 5 minutes after turning headlamp ON), and then check that headlamp operates normally without blinking or flickering.
    3. In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
    4. Turn headlamp ON for approximately 30 minutes, and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Refer to SYMPTOM TABLE .

scientia non olet · About LEMON Manuals