Configuration (High Beam Assist Control Module): Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing high beam assist control module. (For details, refer to WORK PROCEDURE .)

Configuration has three functions as follows.

Function	Description
READ CONFIGURATION	Reads the vehicle configuration of current high beam assist control module. Saves the read vehicle configuration.
WRITE CONFIGURATION - Manual selection	Writes the vehicle configuration with manual selection.
WRITE CONFIGURATION - Config file	Writes the vehicle configuration with saved data.

CAUTION:

When replacing high beam assist control module, always perform "WRITE CONFIGURATION" with CONSULT. Or not doing so, high beam assist control module control function does not operate normally.
Complete the procedure of "WRITE CONFIGURATION" in order.