Diagnostic Test

WRITING MODE SELECTION

CONSULT Configuration
1. Turn ignition switch ON.
2. Select "Configuration" mode of "ADAPTIVE LIGHT" using CONSULT.
When writing saved data

GO TO STEP 2 .

When writing manually

GO TO STEP 3 .

PERFORM "WRITE CONFIGURATION - Config file"

CONSULT Configuration

Perform "WRITE CONFIGURATION - Config file".

WORK END

PERFORM "WRITE CONFIGURATION - Manual selection"

CONSULT Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Identify the correct model and configuration list. Refer to CONFIGURATION LIST .
3. Confirm and/or change setting value for each item.
  CAUTION:
  Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
  
  NOTE:
  If items are not displayed, touch "SETTING". Refer to CONFIGURATION LIST for written items and setting value.
4. Select "SETTING".
  CAUTION:
  Make sure to select "SETTING" even if the indicated configuration of brand new AFS control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model cannot be memorized.
5. When "COMMAND FINISHED", touch "End".
WORK END