Diagnostic Test
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to DESCRIPTION .
NOTE:If "READ CONFIGURATION" cannot be used, use the "WRITE CONFIGURATION - Manual selection" after replacing AFS control unit.
GO TO STEP 2 .
- REPLACE AFS CONTROL UNIT
Replace AFS control unit. Refer to REMOVAL AND INSTALLATION .
GO TO STEP 3 .
- WRITING VEHICLE SPECIFICATION
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. Refer to DESCRIPTION .
GO TO STEP 4 .
- SENSOR INITIALIZE
Perform "SENSOR INITIALIZE". Refer to DESCRIPTION .
WORK END