Diagnostic Test

1. Turn ignition switch OFF.
2. Disconnect front combination lamp connector.
3. Check continuity between front combination lamp harness connector and ground.

   Front combination lamp			-	Continuity
   Connector		Terminal
   RH	E42	3	Ground	Existed
   LH	E41

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair or replace harness.

Install the normal front combination lamp to the applicable headlamp. Check that the headlamp is turned ON. Refer to WORK PROCEDURE .

Is the headlamp turned ON?

YES 

Replace front combination lamp. Refer to REMOVAL AND INSTALLATION .

NO 

LED headlamp is normal. Check headlamp control system.