Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ICC STEERING SWITCH

Turn ignition switch OFF.
Disconnect combination switch (spiral cable) harness connector.

Check resistance between combination switch harness connector terminals as per the following conditions.

Combination switch (Spiral cable)			Condition	Resistance (Ω)
Connector	+	-
Connector	Terminal
M303	13	16	MAIN switch: Pressed	Approx. 0
			Dynamic driver assistance switch: Pressed	Approx. 267
			CANCEL switch: Pressed	Approx. 615
			DISTANCE switch: Pressed	Approx. 1, 090
			SET/COAST switch: Pressed	Approx. 1, 805
			RESUME/ACCELERATE switch: Pressed	Approx. 2, 985
			All ICC steering switches: Released	Approx. 5, 415

Is the inspection result normal?

YES

INSPECTION END

Replace steering wheel. Refer to REMOVAL AND INSTALLATION .