DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

PREPARATION BEFORE STARTING OPERATIONS

If other DTC confirmation procedure is performed immediately before this procedure, turn the ignition switch OFF and wait at least 10 seconds to start the next test.

GO TO STEP 2 .

PERFORM DTC CONFIRMATION PROCEDURE

WITH CONSULT
1. Perform work procedure (inspection mode 5). Refer to WORK PROCEDURE (INSPECTION MODE 5) .
2. Start the engine and wait for 5 seconds or more.
3. Perform "All DTC Reading" with CONSULT.
4. Check if the DTC is detected in "Self Diagnostic Result" of "MOTOR CONTROL".
Is U0100, U0101, U0111 or U0293 detected?

YES

GO TO STEP 3 .

NO-1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2

Confirmation after repair: INSPECTION END

PERFORM CAN DIAGNOSIS

WITH CONSULT
1. Perform "CAN DIAGNOSIS"
2. Check diagnosis result.
Refer to DIAGNOSIS PROCEDURE .