Component Inspection (Selector Lever Position Indicator)

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SELECTOR LEVER POSITION INDICATOR

Check that selector lever position indicator lamps turn on.

CAUTION:

Connect the fuse between the terminals when applying the voltage.

Selector lever position indicator		Condition	Status
+ (fuse)	-
Terminal
2	7	Apply 12 V direct current between terminals 2 and 7.	"N" position indicator lamp turns on.
3		Apply 12 V direct current between terminals 3 and 7.	"D" position indicator lamp turns on.
4		Apply 12 V direct current between terminals 4 and 7.	"R" position indicator lamp turns on.
5		Apply 12 V direct current between terminals 5 and 7.	"P" position indicator lamp turns on.
6	9	Apply 12 V direct current between terminals 6 and 9.	"M" mode indicator lamp turns on.
10	11	Apply 12 V direct current between terminals 10 and 11.	Illumination lamp turns on.

Is the inspection result normal?

YES

INSPECTION END

Replace selector lever position indicator. Refer to REMOVAL AND INSTALLATION .