Diagnostic Test
- CHECK TCM POWER SOURCE (PART 1)
- Turn ignition switch OFF.
- Disconnect A/T assembly connector.
- Check voltage between A/T assembly harness connector terminal and ground.
+ - Condition Voltage
(Approx.)A/T assembly Connector Terminal F2 2 Ground Always Battery voltage
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
GO TO STEP 4 .
- CHECK TCM POWER SOURCE (PART 2)
Check voltage between A/T assembly harness connector terminals and ground.
+ - Condition Voltage
(Approx.)A/T assembly Connector Terminal F2 1 Ground Turn ignition switch ON Battery voltage Turn ignition switch OFF 0 V 6 Turn ignition switch ON Battery voltage Turn ignition switch OFF 0 V Is the inspection result normal?
YES
GO TO STEP 3 .
NO
GO TO STEP 5 .
- CHECK TCM GROUND CIRCUIT
Check continuity between A/T assembly harness connector terminals and ground.
A/T assembly - Continuity Connector Terminal F2 5 Ground Existed 10 Is the inspection result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Repair or replace damaged parts.
- DETECT MALFUNCTIONING ITEM (PART 1)
Check the following items:
- Open circuit or short circuit in harness between battery positive terminal and A/T assembly harness connector terminal 2. Refer to WIRING DIAGRAM - BATTERY POWER SUPPLY - .
- Battery
- 10A fuse (No. 68, fuse and fusible link block). Refer to FUSE AND FUSIBLE LINK ARRANGEMENT .
Is the inspection result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Repair or replace damaged parts.
- CHECK HARNESS BETWEEN IPDM E/R AND A/T ASSEMBLY
- Turn ignition switch OFF.
- Disconnect IPDM E/R connector.
- Check continuity between IPDM E/R harness connector terminal and A/T assembly harness connector terminals.
IPDM E/R A/T assembly Continuity Connector Terminal Connector Terminal E123 61 F2 1 Existed 6 - Also check short circuit in harness.
Is the inspection result normal?
YES
GO TO STEP 6 .
NO
Repair or replace damaged parts.
- DETECT MALFUNCTIONING ITEM (PART 2)
Check the following items:
- Open circuit or short circuit in harness between ignition switch and IPDM E/R. Refer to WIRING DIAGRAM - IGNITION POWER SUPPLY - .
- 10A fuse (No. 51, IPDM E/R). Refer to FUSE, CONNECTOR AND TERMINAL ARRANGEMENT .
- IPDM E/R
Is the inspection result normal?
YES
Check intermittent incident. Refer to INTERMITTENT INCIDENT .
NO
Repair or replace damaged parts.