Component Function Check

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

COMPONENT FUNCTION CHECK

With CONSULT

Start the engine.
Shift the selector lever to "P" position.
Select "Data Monitor" in "AT/CVT".
Select "ATF TEMP 1".
Warm up until the below condition is satisfied.

ATF TEMP 1 : 45 - 55°C (113 - 131°F)
Select "Data Monitor" in "MOTOR CONTROL".
Select "SUB E-OP PRESSURE" and "SUB E-OP TORQUE".
Set the vehicle to idling stop state.

Check value.

SUB E-OP PRESSURE	: Approx. 550 kPa
SUB E-OP TORQUE	: 0.52 - 0.62 Nm

Is the inspection result normal?

YES-1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

YES-2

Confirmation after repair: INSPECTION END

Go to DIAGNOSIS PROCEDURE .