DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

"DIAGNOSIS PROCEDURE " must be performed before starting "DTC CONFIRMATION PROCEDURE".
Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
Always drive vehicle at a safe speed.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT

Start the engine.
Select "SLCT LVR POSI" and "GEAR" in "Data Monitor" in "TRANSMISSION".

Drive vehicle the following condition.

SLCT LVR POSI	: D
GEAR	: 1st through 7th
VHCL/S SE-A/T	: 25 km/h (16 MPH) or more

Check DTC.

With GST

Follow the procedure "With CONSULT".

Is "P1730" detected?

YES

Go to DIAGNOSIS PROCEDURE .

INSPECTION END