DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

"DIAGNOSIS PROCEDURE " must be performed before starting "DTC CONFIRMATION PROCEDURE".
Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
Always drive vehicle at a safe speed.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT

Start the engine.
Select "SLCT LVR POSI", "ACCELE POSI" and "GEAR" in "Data Monitor" in "TRANSMISSION".

Drive vehicle and maintain the following conditions.

SLCT LVR POSI	: D
ACCELE POSI	: More than 1.0/8
GEAR	: 3rd → 4th or 6th → 7th

Check DTC.

With GST

Follow the procedure "With CONSULT".

Is "P0780" detected?

YES

Go to DIAGNOSIS PROCEDURE .

INSPECTION END