Component Function Check

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK COMBINATION METER INPUT SIGNAL

Turn ignition switch ON.

Measure voltage between the following terminals of the combination meter.

Combination meter			Condition	Voltage (Approx.)
Connector	Terminals
	(+)	(-)
M57	36	17	When illumination control switch (+) is pressed	0 V
			Other than the above	5 V
	37		When illumination control switch (-) is pressed	0 V
			Other than the above	5 V
	18		When trip reset switch is pressed	0 V
			Other than the above	5 V

Is the inspection result normal?

YES

INSPECTION END

Refer to DIAGNOSIS PROCEDURE .