Diagnosis Procedure
- CHECK FUSE
Check that the following fuse is not blown.
Signal name Fuse No. Battery power supply 79 Is the fuse fusing?
YES
Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO
GO TO STEP 2.
- CHECK INVERTER UNIT POWER SUPPLY CIRCUIT
Check voltage between inverter unit harness connector and ground.
Terminal Condition Voltage
(Approx.)(+) (-) Inverter unit Ground Ignition switch Connector Terminal M143 4 OFF Battery voltage Is the inspection result normal?
YES
GO TO STEP 3.
NO
Repair or replace the inverter unit power supply circuit.
- CHECK INVERTER UNIT GROUND CIRCUIT
- Turn the ignition switch OFF.
- Disconnect the inverter unit connector.
- Check for continuity between inverter unit harness connector and ground.
Inverter unit Ground Continuity Connector Terminal M143 8 Existed
Is the inspection result normal?
YES
INSPECTION END
NO
Repair or replace the inverter unit ground circuit.