Diagnosis Procedure
- CHECK FUSE
Check that the following fuse is not blown.
Signal name Fuse No. Ignition power supply 3 Is the fuse fusing?
YES
Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO
GO TO STEP 2.
- CHECK POWER SUPPLY FOR AC 120 V OUTLET MAIN SWITCH
- Turn ignition switch ON.
- Check for voltage between the AC 120 V main switch harness connector and ground.
Terminals Condition Voltage
(Approx.)(+) (-) AC 120 V outlet main switch Ground Ignition switch Connector Terminal M144 1 OFF 0 V ON Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
Repair the AC 120 V main switch power supply circuit.