LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> QX80 Limited >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System (Symptom Diagnosis & Removal And Installation) >> Periodic Maintenance >> Front Fog Lamp Aiming Adjustment >> Aiming Adjustment Procedure

Aiming Adjustment Procedure

  1. Place the screen.
    NOTE:
    • Stop the vehicle facing the wall.
    • Place the board on a plain road vertically.
  2. Face the vehicle with the screen. Maintain 10 m (32.8 ft) between the front fog lamp center and the screen.
  3. Start the engine. Turn the front fog lamp ON.
    NOTE:

    Shut off the headlamp light with the board to prevent from illuminating the adjustment screen.

    CAUTION:

    Never cover the lens surface with a tape etc. The lens is made of resin.

  4. Adjust the cutoff line height (A) with the aiming adjustment screw so that the distance (X) between the horizontal center line of front fog lamp (H) and (A) becomes 150 mm (5.91 in).

    Front fog lamp light distribution on the screen 

    G00479813Courtesy of NISSAN NORTH AMERICA, INC.
    A : Cutoff line
    B : High illuminance area
    H : Horizontal center line of front fog lamp
    V : Vertical center line of front fog lamp
    X : Cutoff line height
scientia non olet · About LEMON Manuals