Diagnosis Procedure
- CHECK POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect auto anti-dazzling inside mirror (homelink universal transceiver) connector.
- Check voltage between auto anti-dazzling inside mirror (home link universal transceiver) harness connector and ground.
Auto anti-dazzling inside mirror
(Homelink universal transceiver) connectorTerminal Condition Voltage (V)
(Approx.)R3 10 Ground Ignition switch position: OFF Battery voltage 6 Ignition switch position: ON Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Check the following items.
- 10A fuse [No. 3 located in the fuse block (J/B)]
- 10A fuse [No. 6 located in the fuse block (J/B)]
- Harness for open or short between fuse and auto anti-dazzling inside mirror (homelink universal transceiver).
- CHECK GROUND CIRCUIT
Check continuity between auto anti-dazzling inside mirror (homelink universal transceiver) harness connector and ground.
Auto anti-dazzling inside mirror
(Homelink universal transceiver) connectorTerminal Ground Continuity R3 8 Existed Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair harness.
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
INSPECTION END