LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2016 >> QX70 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 (Steering Control System (Diagnostic Trouble Codes (DTCS) C13D4-00 - U1010-49 And Circuit Diagnosis) (Hybrid)) >> DTC/Circuit Diagnosis >> DTC C13F0-00: INCOMP DAST Calibration >> EPS/DAST 3 >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

  1. PERFORM CALIBRATION

    Perform the working including "DAST CALIBRATION (MODE 1)" performed just before from the first. Refer to WORK PROCEDURE .

    GO TO STEP 2  .

  2. PERFORM SELF-DIAGNOSIS

    G-20With CONSULT 

    1. Turn the ignition switch ON.
    2. Erase self - diagnosis for "EPS/DAST 3".
    3. Turn the ignition switch OFF and wait for at least 10 seconds.
    4. Turn the ignition switch ON.
    5. Perform self - diagnosis for "EPS/DAST 3".

    Is DTC "C13F0 - 00" detected?

    YES 

    Replace steering force control module. Refer to REMOVAL AND INSTALLATION .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals