Diagnostic Test
WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK THE TEMPERATURE OF CONTROL MODULE
With CONSULT
- Set the vehicle to READY state or start the engine.CAUTION:
Never drive the vehicle.
- On the CONSULT screen, select "DAST 1">>"DATA MONITOR">>"C/M TEMPERATURE".
- Wait with the ignition switch OFF until the data monitor indication becomes 80°C (176°C) or less.
Does the temperature drop to 85°C (185°C) or less?
YES
GO TO STEP 2 .
NO
Replace steering angle main control module. Refer to REMOVAL AND INSTALLATION .
- Set the vehicle to READY state or start the engine.
- PERFORM SELF-DIAGNOSIS
- Turn the ignition switch ON.
- Erase self-diagnosis for "DAST 1".
- Turn the ignition switch OFF and wait for at least 10 seconds.
- Set the vehicle to READY state or start the engine.CAUTION:
Never drive the vehicle.
- Perform self-diagnosis for "DAST 1".
Is DTC "C13E6 - 00" detected?
YES
Replace steering angle main control module. Refer to REMOVAL AND INSTALLATION .
NO
The rise of steering angle main control module internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END