Special Repair Requirement
- CHOOSE METHOD
There are two ways of setting method.
Which method do you choose?
With set switch
GO TO STEP 2 .
With CONSULT-III
GO TO STEP 6 .
- WITH SET SWITCH - STEP 1
- Turm ignition switch OFF.
- Push setting button and hold for more than 10 seconds.
GO TO STEP 3 .
- CONFIRM THE OPERATION
Check the entry/exit assist function setting is changed.
Is the setting changed?
YES
GO TO STEP 4.
NO
GO TO STEP 1.
- WITH SET SWITCH - STEP 2
- Turm ignition switch ACC
- Push setting button and hold for more than 10 seconds.
GO TO STEP 5.
- CONFIRM THE OPERATION
Check the seat synchronization function setting is changed.
Is the setting changed?
YES
END
NO
GO TO STEP 1.
- WITH CONSULT-III - STEP 1
Select "Work support".
GO TO STEP 7 .
- WITH CONSULT-III - STEP 2
- Select "EXIT SEAT SLIDE SETTING", "EXIT TILT SETTING" or "SEAT SLIDE VOLUME SET" then touch display to change between ON and OFF.
- EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
- EXIT TILT SETTING: Entry/exit assist (steering column)
- Then touch "OK".
GO TO STEP 8.
- Select "EXIT SEAT SLIDE SETTING", "EXIT TILT SETTING" or "SEAT SLIDE VOLUME SET" then touch display to change between ON and OFF.
- CONFIRM THE OPERATION
Check the entry/exit assist function setting is changed.
Is the setting changed?
YES
END
NO
GO TO STEP 1.