Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CONNECTOR CHECK
   
   

   Check the AV control unit, BOSE speaker amp. and speaker connectors for the following:

   • Proper connection
   • Damage
   • Disconnected or loose terminals

   Is the inspection result normal?

   YES 

   GO TO STEP 2  .

   NO 

   Repair the terminals or connectors.

2. CHECK FRONT TWEETER SIGNAL CIRCUIT CONTINUITY
   
   
   1. Disconnect BOSE speaker amp. connector B121 and suspect front tweeter connector.
   2. Check continuity between BOSE speaker amp. connector B121 and suspect front door speaker connector.

      BOSE speaker amp.		Front tweeter		Continuity
      Connector	Terminal	Connector	Terminal
      B121	45	M109 (LH)	1	Yes
      	46		2
      	41	M111 (RH)	1
      	42		2

   3. Check continuity between BOSE speaker amp. connector B121 and ground.

      BOSE speaker amp.		Ground	Continuity
      Connector	Terminal
      B121	45	-	No
      	46
      	41
      	42

   Is the inspection result normal?

   YES 

   GO TO STEP 3  .

   NO 

   Repair or replace harness or connectors.

3. CHECK FRONT TWEETER SIGNAL
   
   
   1. Connect BOSE speaker amp. connector B121 and suspect front tweeter connector.
   2. Turn ignition switch to ACC.
   3. Push AV control unit POWER switch.
   4. Check signal between terminals of BOSE speaker amp. connector B121.

      BOSE speaker amp. connector B121		Condition	Reference value
      (+)	(-)
      Terminal	Terminal
      45	46	Audio signal output	Courtesy of NISSAN NORTH AMERICA, INC.
      41	42

   Is the inspection result normal?

   YES 

   Replace front tweeter. Refer to REMOVAL AND INSTALLATION .

   NO 

   GO TO STEP 4  .

4. CHECK PRE-AMP SIGNAL CIRCUIT CONTINUITY
   
   
   1. Disconnect AV control unit connector M161 and BOSE speaker amp. connector B120.
   2. Check continuity between AV control unit connector M161 and BOSE speaker amp. connector B120.

      AV control unit		BOSE speaker amp.		Continuity
      Connector	Terminal	Connector	Terminal
      M161	2	B120	25	Yes
      	3		5
      	11		26
      	12		6

   3. Check continuity between AV control unit connector M161 and ground.

      AV control unit		Ground	Continuity
      Connector	Terminal
      M161	2	-	No
      	3
      	11
      	12

   Is the inspection result normal?

   YES 

   GO TO STEP 5. 

   NO 

   Repair or replace harness or connectors.

5. CHECK PRE-AMP SIGNAL
   
   
   1. Connect AV control unit connector M161 and BOSE speaker amp. connector B120.
   2. Turn ignition switch to ACC.
   3. Push AV control unit POWER switch.
   4. Check signal between the terminals of AV control unit connector M161.

      AV control unit connector M161		Condition	Reference value
      (+)	(-)
      Terminal	Terminal
      2	3	Audio signal output	Courtesy of NISSAN NORTH AMERICA, INC.
      11	12

   Is the inspection result normal?

   YES 

   Replace BOSE speaker amp. Refer to REMOVAL AND INSTALLATION .

   NO 

   Replace AV control unit. Refer to REMOVAL AND INSTALLATION .