Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK FRONT SONAR SENSOR RH INNER CIRCUIT CONTINUITY
   
   
   1. Turn ignition switch OFF.
   2. Disconnect sonar control unit connector M70 and front sonar sensor RH inner connector E310.
   3. Check continuity between sonar control unit connector M70 and front sonar sensor RH inner connector E310.

      Sonar control unit		Front sonar sensor RH inner		Continuity
      Connector	Terminal	Connector	Terminal
      M70	1	E310	2	Yes
      	13		1

   4. Check continuity between sonar control unit connector M70 and ground.

      Sonar control unit		Ground	Continuity
      Connector	Terminal
      M70	1	-	No

   Is the inspection result normal?

   YES 

   GO TO STEP 2  .

   NO 

   Repair or replace harness or connectors.

2. CHECK FRONT SONAR SENSOR RH INNER SIGNAL CIRCUIT SHORT TO BATTERY
   
   
   1. Turn ignition switch ON.
   2. Check voltage between sonar control unit connector M70 and ground.

      Sonar control unit		Ground	Voltage (Approx.)
      Connector	Terminal
      M70	1	-	0V

   Is the inspection result normal?

   YES 

   Replace front sonar sensor RH inner. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness or connectors.