Component Inspection

REMOVE FUEL LEVEL SENSOR UNIT

Remove the fuel level sensor unit. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 2.

CHECK FUEL LEVEL SENSOR UNIT AND FUEL PUMP

Check the resistance between terminals 2 and 5.

Fig 1: Checking Fuel Level Sensor Unit And Fuel Pump

Courtesy of NISSAN NORTH AMERICA, INC.

Terminal		Float position mm (in)			Resistance value (Approx.)
2	5	*1	Empty	15.7 (0.6)	283Ω
2	5	*2	Full	133 (5.2)	51Ω

*1 and *2: When float arm is in contact with stopper.

Is inspection result OK?

YES

Inspection End.

Replace fuel level sensor unit and fuel pump. Refer to REMOVAL AND INSTALLATION .