Operation Procedure
- Turn ignition switch ON, and switch the trip meter to "trip A" or "trip B".NOTE:
If the diagnosis function is activated with "trip A" displayed, the mileage on "trip A" is reset to "0000.0". (The same way for "trip B".)
- Turn ignition switch OFF.
- While pressing the trip A/B reset switch (1), turn ignition switch ON again.
- Make sure that the trip meter displays "0000.0".
- Press the trip A/B reset switch at least 3 times. (Within 7 seconds after the ignition switch is turned ON.)
- The unified meter control unit is turned to self - diagnosis mode.
- Displays "888888" (1) and "8888.8" (2) in the information display LCD (3) for approximately 5 seconds and then blinks the segment dots of the information display LCD alternately.
- Water temperature gauge and fuel gauge return to zero, and at the same time.
NOTE:- Check combination meter power supply and ground circuit when self - diagnosis mode of combination meter does not start. Replace combination meter if normal.
- If any of the segments is not displayed, replace combination meter.
- Displays "888888" (1) and "8888.8" (2) in the information display LCD (3) for approximately 5 seconds and then blinks the segment dots of the information display LCD alternately.
- Each meter activates during pressing trip A/B reset switch.NOTE:
- If any of the meter and gages is not activated, replace combination meter.
- The figure is reference.