Diagnosis Procedure

Perform auto active test. Refer to DIAGNOSIS DESCRIPTION .

Does oil pressure warning lamp blink?

YES 

GO TO STEP 2  .

NO 

Replace combination meter.

1. Disconnect the oil pressure switch connector.
2. Turn ignition switch ON.
3. Check voltage between the oil pressure switch harness connector and ground.

   Terminals			Voltage
   (+)		(-)
   Oil pressure switch		Ground
   Connector	Terminal
   F37	1		Approx. 12 V

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 4  .

Perform a unit check for the oil pressure switch. Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

NO 

Replace oil pressure switch.

Check the oil pressure switch signal circuit. Refer to DIAGNOSIS PROCEDURE .

Is the inspection result normal?

YES 

Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

NO 

Repair harness or connector.