Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK METER CONTROL SWITCH SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect combination meter connector and meter control switch connector.

Check continuity between combination meter harness connector and meter control switch harness connector.

Terminals				Continuity
Combination meter		Meter control switch
Connector	Terminal	Connector	Terminal
M57	17	M59	4	Existed
	18		5
	36		6
	37		7

Check continuity between combination meter harness connector and ground.

Combination meter		Ground	Continuity
Connector	Terminal
M57	17		Not existed
	18
	36
	37

Is the inspection result normal?

YES

GO TO STEP 2 .

NO

Repair harness or connector.

CHECK METER CONTROL SWITCH

Check meter control switch. Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES

Replace combination meter. Refer to REMOVAL AND INSTALLATION .

NO

Replace meter control switch. Refer to REMOVAL AND INSTALLATION .